Note: You will be prompted in the Phyn App when it is time to put the Sensor into Pairing Mode. Putting the Sensor into Pairing Mode too early might cause Pairing Mode to time out before it is time to pair.
If the Sensor had been previously paired, you will need to perform a hard reset to restore it to factory settings.
Follow these steps to put the Phyn Smart Water Sensor into Pairing Mode.
- When prompted in the Phyn App, press and release the button on the side of the Water Sensor
- The Phyn logo in the center of the Sensor will start flashing on and off blue and white
- The device is in now in Pairing Mode
Note: If you do not see the Phyn logo illuminate, repeat the process ensuring that you have done a button press and release.